CW Touch Paddles – Model P3NS

No Soldering Required

DUAL TOUCH PADDLE CIRCUIT CARD

  Thousand already sold!  

  Just add your own creative conductive metal paddle.

     No Moving Parts or Contacts to Wear Out           

No Adjusting Required          

No Falsing

Superior Response 

ONLY 1.15″ W x .815″ D x .4″ H

P3ns A

This small circuit card replaces standard mechanical dual paddles.

Bencher 1

Use anything metal to make your own custom paddles.or buy a set of paddles from us.

HIGHLY RESPONSIVE WITH THE SLIGHTEST TOUCH

   * SELF CALIBRATING ON POWER-UP

   * NOT AFFECTED BY  MOISTURE, DRYNESS or DIRT

   * < 2 mA POWER CONSUMPTION   

   * IDEAL FOR CUSTOM PADDLE DESIGNS.

   ORDER YOURS TODAY!!!

          Use your imagination to create your perfect paddle.

Create your own set of touch paddles using just about any conductive metal and wire

them to the model P3 circuit card.  (up to 24″ away)

 Model P3 circuit card is so small (ONLY 1.15″ W x .815″ D x .4″ H)

it can fit inside most homebrew equipment.

 Operates on 6-14 DC volts. Positive Keying of 13.8 Volts or Less.

 Paddle separation: > .25″ (To prevent capacitive paddle interaction paddles should be separated by a minimum of .25″.

However, this specification will vary with paddle size.)

Output:Open dran FET.  +13.8 volts, 60 mA or less.  
Non-touched paddleInfinity Ohms
Touched paddle<5 ohms
Output ResponseDirectly proportional to the paddle touch time.
Paddles must not touch any other metal object! 

Can be used as a STRAIGHT KEY also.

Simply use just one paddle, connect it to your “key-in” point and tap away on your code.

P3ns A (1)